Уважаемые коллеги ! Наверняка я не первый у кого возник этот вопрос: каким образом можно освободить ячейку памяти (REGULAR MEMORY CHANNEL), занятую ранее сохранённой информацией, как это описано на стр.34 оригинального руководства к Yaesu VX-6R ?
Принципиально задача сводится к тому, чтобы перевести выбранную ячейку памяти в статус 'free', после чего она должна появляться в списке “next-available ‘free’ channel”. Описанная на стр.38 упомянутого руководства в разделе MASKING MEMORIES последовательность действий, как и следует из названия, лишь "маскирует" ячейку памяти, предоставляя возможность восстановить находящиеся в ней данные:
========================================================
MASKING MEMORIES
There may be situations where you want to “Mask” memories so they are not visible during
memory selection or scanning. For example, several memories used only in a city you visit
infrequently may be stored, then “Masked” until you visit that city, at which time you can
“Unmask” them for normal use.
1. Press the [V/M(DW)MT] key, if needed, to enter the MR mode.
2. Press and hold in the [F/W] key for one second, then rotate the DIAL knob to select the
memory channel to be “Masked.”
3. Press the [ (LK)TXPO] key momentarily. The display will revert to memory channel
#1. The previously-selected memory will be Masked.
4. To Unmask the hidden memory, repeat the above procedure: press and hold in the [F/
W] key for one second, rotate the DIAL to select the masked memory’s number, then
press the [ (LK)TXPO] key to restore the memory channel’s data.
Watch out! You can manually store data over a “Masked” memory, deleting
previous data, if you’re not careful. Use the “next available memory” technique
(look for the blinking memory channel number) storage technique to
avoid over-writing a masked memory.
========================================================
http://www.yaesu.com --> VX-6R --> Files --> VX-6R Operating Manual ( 2.50 MB )